New OEM Mercruiser Bravo I, II & III Bellows Repair Kit

Bravo 3 Bellows Replacement. Bravo III / 3 outdrive repair all bellows, gimbal brg, install raw I decided to have the marina replace the Bravo 3 bellows, gimbal bearing, lube, winterize, plugs, etc From a bellows replacement standpoint, I don't think there is really much difference between an Alpha I Gen II and Bravo I or Bravo III, the shift cable is a little different, but the 3 bellows - u-joint, exhaust and shift cable along with the gimbal bearing are not - a little bigger than the Alpha, but the procedure to change them is the same.

Hey guys, 5.7L Mercruiser Bravo III outdrive Working on: replace all bellows, gimbal bearing, oil seal behind gimbal, raw water pump (on engine) My original bellows lasted 10 years (wet slipped in salt 6 months every year) Aug 1, 2020 #4

Bravo III UJoint bellows retaining ring, Any tricks? Club Sea Ray

I inspected the work done yesterday and noticed that the exhaust bellow that. Bellows lifespan is very dependent on where boat is used and stored - but should last a minimum of 5yrs.. Thread starter abl1111; Start date Feb 15, 2012; A

New OEM Mercruiser Bravo I, II & III Bellows Repair Kit. (I have a couple of threads here in the Mercruiser section that you can view) Gimbal bearings are easy. The shift setup is a little different, if anything the B3 is easier and quicker to replace.

Mercruiser Bravo 3 bellows/gear lube line replacement. YouTube. Hey guys, 5.7L Mercruiser Bravo III outdrive Working on: replace all bellows, gimbal bearing, oil seal behind gimbal, raw water pump (on engine) My original bellows lasted 10 years (wet slipped in salt 6 months every year) Aug 1, 2020 #4